Help building the largest human-edited directory of the web Suggest URL - Open Directory Project - Become an editor

directopedia.org uses links and structure from dmoz Open Directory Project.
The contents has been generating using technology developed by scientec.

This article is about distributors in internal combustion engines. For distributors in the film industry, see film distributor.

The distributor in the ignition system of an internal combustion engine is a device which routes the high voltage in the correct firing order to the spark plugs.

It consists of a rotating arm or rotor inside the distributor cap, on top of the distributor shaft. The rotor contacts the central high voltage cable from the coil via a spring loaded carbon brush. The rotor arm passes close to (but does not touch) the output contacts which connect via high tension cables to the spark plug of each cylinder. Within the distributor, the high voltage energy is able to jump the small gap from the rotor arm to the contact.

The distributor shaft has a cam that operates the contact breaker. Opening the points causes a high induction voltage in the system's ignition coil.

The distributor also houses the centrifugal advance unit: a set of hinged weights attached to the distributor shaft, that cause the breaker points mounting plate to slightly rotate and advance the spark timing with higher engine rpm. In addition, the distributor has a vacuum advance unit that advances the timing even further as a function of the vacuum in the inlet manifold. Usually there is also a capacitor attached to the distributor. The capacitor is connected parallel to the breaker points, to suppress sparking and prevent wear of the points.

Around the 1970s the primary breaker points were largely replaced with Hall effect sensors. As this is a non-contacting device and the primary circuit is controlled by solid-state electronics, a great amount of maintenance in point adjustment and replacement was eliminated. This also eliminates any problem with breaker follower or cam wear, and by eliminating a side load extends distributor shaft bearing life. The remaining secondary (high voltage) circuit was as described above, using a single coil and a rotary distributor.

Direct ignition

Modern engine designs are tending to do away with the distributor and coil, instead performing the distribution function in the primary circuit electronically and applying the primary pulse to individual coils on top of each spark plug (Direct Ignition or coil-on-plug). This avoids the need to switch very high voltages, which is very often a source of trouble, especially in damp conditions.

Patents

• U.S. Patent 1474970 - Ignition apparatus - Arthur Atwater Kent
• U.S. Patent 1476522 - Ignition apparatus - Arthur Atwater Kent
• U.S. Patent 1560246 - Ignition apparatus - Arthur Atwater Kent
• U.S. Patent 1560247 - Ignition apparatus - Arthur Atwater Kent
• U.S. Patent 1570680 - Ignition apparatus - Arthur Atwater Kent
• U.S. Patent 1591424 - Ignition apparatus - Arthur Atwater Kent
• U.S. Patent 1219704 - Ingnition system - Frank Conrad

See also

• electronic control unit

This article is based on the article "Distributors" from Wikipedia - the free encyclopedia created and edited by online user community. This article is distributed under the terms of GNU Free Documentation License. Here you find the list of authors of this article. The article can only edited within Wikipedia. Edit this article in Wikipedia.